General Description

Using low power CMOS process, the AS1820 is
designed for low power, high performance unipolar
detection dual output hall-effect application, such as
cover switch, contactless switch, solid state switch and
lid close sensor etc battery operation. The hall IC
integrated an on-chip hall voltage generator for
magnetic sensing, a comparator that amplifiers the hall
voltage, a chopper amplifier, a Schmitt trigger to
provide switching hysteresis for noise rejection, and
two complementary output.
The total power consumption of AS1820 is
typically less than 1.5uA at 1.8V power supply. AS1820
is designed to respond to alternating North and South
poles. White the magnetic flux density (B) is larger than
operate point (BOP), the output will be turned on (low),
the output is held until the magnetic flux density (B) is
lower than release point (BRP), then turn off (high).
The device is available in DFN1014-4L, SOT553
and SOT23-5L Packages and is rated over the -40°C
to 85°C. The all packages are RoHS and Green
compliant.

Features

 Input Voltage Range : 1.65V to 5.0V
 Micro-power consumption ideal for battery
power applications
 Uniplar Operation, dual output
 Very high sensitivity hall sensor
 Low Power CMOS process technology
 Chopper stabilization amplifier stage
 Magnetic Sensitivity (typical)
BOPS=30Gauss, BRPS=20Gauss
BOPN= -30Gauss, BRPN= -20Gauss
 Good RF noise immunity
 No need pull-up resistor
 Small Solution Size
 RoHS & Green Compliant
 DFN1014-4L, SOT553 & SOT23-5L Packages
 -40℃ to +85 ℃ Temperature Range

Applications

 Cover switch in clam-shell cellular phones
 Cover switch in Notebook, PC/PAD
 Contact-less switch in consumer products
 Solid State Switch
 Handheld Wireless Handset Awake Switch
 Lid close sensor for battery-powered devise
 Magnet proximity sensor for reed switch
replacement in low duty cycle applications
 DV, DSC, and White Goods